The GRID 20 remote entry device provides intuitive remote access and control of the entire Garmin nautical system. It has a 360-degree joystick with a rotating wheel and a selection button to facilitate navigation through the settings and the plotter menus, as well as to provide you with optimal control even in the most adverse conditions. Allows you to designate four favorite keys to reset the system to a previously saved configuration. It also allows you to configure some hard keys to quickly access important functions, such as changing the left and right screen, the activation and standby mode of the autopilot and much more. In addition, for you to enjoy greater peace of mind, there is also a dedicated SOS button. Wireless or wired installation options, or vertical or horizontal, offer a plug-and-play solution adapted to your nautical system. Its compact design facilitates its integration into the bridge, between the different screens or even in the arm of the captain’s chair.
Details
- Intuitive access and remote control of the entire Garmin nautical system
- All-in-one 360-degree joystick with a swivel wheel and a selection button
- Simple navigation through the configuration and menus of the plotter, and optimal control in any situation
- Four favorite keys that can be configured to reset the system to a previously saved configuration
- Wireless or wired installation options
Specifications:
- Dimensions (width x height x depth): 14.1 X 5.6 X 6.8 cm
- Weight: 179 g
- Temperature range: from -15 °C to 70°C
- Material: fully sealed and high-strength plastic alloy
- Water resistance rating: IPX7
- Safety distance of the compass: 114 mm
- Power input:
- NMEA 2000
- Cable power (with the included power cable):
- Input power: 9-32 V DC
- Fuse: fast from 1.0 A
- Maximum power consumption at 9 V DC: 1.5 W
- Typical current consumption at 12 V of DC: 40 mA
- Maximum current consumption at 12 V DC: 120 mA
- Input power: 9-32 V DC
- 2 AA batteries (not included)
FAQs
Yes, apply marine-grade sealant between the mounting surface and device to prevent leakage.
Remove the protective liner from the foam gasket’s adhesive and ensure proper installation before mounting.
Use only the template included in the product box. If you print your own, ensure the paper and printer size are accurate to prevent incorrect cuts.
Apply marine sealant between the mounting surface and the device. If there will be access to the back, seal around the cutout for water protection.
It is recommended to use the template included in the box. If printing, improper sizing can cause an incorrect cutout.
Only use the hardware provided in the product box; all necessary mounting hardware is included.
Wear safety goggles, ear protection, and a dust mask when drilling or cutting. Disconnect the vessel’s power supply and install only when the vessel is on land or securely docked.
Yes. Connecting the power cable without the appropriate fuse in place may void the warranty and cause overheating or fire.
Ensure the gasket and battery compartment are free of debris before closing the battery door.
Always check what is on the opposite side of the surface before drilling or cutting to avoid damaging the vessel.
Connect the device to a NMEA 2000 network (for power/data) or use the included power cable. The cables necessary for NMEA 2000 are not included.
No. The device should not be mounted in locations exposed to extreme temperatures. Prolonged exposure to temperatures outside the specified range may cause device failure.
The device must not be mounted closer than 11.4 cm (4.5 in.) to a magnetic compass to avoid interference.
Contact the SailRACE team — as certified marine experts we’re happy to help with product selection, installation and after-sales servicing, before and after your purchase.
